Is there a proper side of the boat to install a depth finder? - how to install a new boat floor
My sounder making false statements when I pull in the water, even at low speeds. I was told to put on the other side of the machine, is that true?
Thursday, December 17, 2009
How To Install A New Boat Floor Is There A Proper Side Of The Boat To Install A Depth Finder?
5 comments:
Can be anywhere, but outside and away from the engine a little fitted. Water turbulence causes air bubbles and the signal can not shoot into the air. Also riding for the what lies beneath the boat about 1 / 8 inch. When you climb up and the plane can from the water. to be hoped that this assistance.
Sometimes it is to interference on the propeller wash of the machine so you can probe a few inches of moving area.If can afford to pay a studio to re-install the probe can be done by Hull somehow it would also larger craft work / motors.I dont think the side sensor mounting an argument, as I have seen on both sides of the boat and they all worked same.mines mounted on the right and works well.
Regards, Brian
The rear panel.
try the first, if not temporarily go in the front, to see if the drive works at all, if the yield is not unity
Yes, it looks like you are always bubbles under the boat. It is necessary to move a little preface, where he is. It is hard to say where they settle, not because you have typw knots this boat. If the sensor is loose rightful place in various areas in the interior of the boat. If you have an external attempt to up or down a little bit installed.
Post a Comment